ESTEBAN CMP-121 Instrucciones De Uso página 6

STARTING THE DIFFUSER
Read the below-mentioned instructions carefully before starting the diffuser.
1
MAX 100 ml
30 min
60 min
LIGHT Non sto p ON/OF F
2
3
STAGE 3
• Press the ON / OFF button:
1 st press, the "30 min" light lights up, diffusion starts and stops automatically after 30 min.
2 press, the "60 min" light lights up, diffusion starts and stops automatically after 60 min.
nd
3 press, the "NON STOP" light lights up, diffusion starts and stops automatically, after around 3 hours, for a maximum
rd
filling level up to 100 ml.
4 th press, the 3 lights go out, the diffusion and the luminous ambiance stop.
30 min
60 min
LIGHT Non sto p ON/OF F
• Thanks to the automatic stop system, you can enjoy the perfumed atmosphere without worrying about the diffuser.
• During the diffusion, the height of the mist may vary.
• When the appliance is operating, make sure not to put any obstacle above the appliance that could hamper the release of the mist and
not to remove the upper parts in order to avoid any splashing.
6
CMP-121_NoticeDifMultiFonc_03-17_v2.indd 6
STAGE 1
• Place the diffuser on a flat and stable surface away from the edge.
• Connect the electricity cable to the port at the back of the diffuser without plugging it in.
• Remove the upper parts A and B. Pour water at room temperature into the container by using
the graduated glass C. Do not exceed the maximum level of 100 ml (Warning: the diffuser
does not work if the water level is too low or higher than 100 ml).
• Do not pour hot water into the container (risk of damage of sensitive components).
• Add a few drops of Estéban refresher oils or essential oils: at least 10, or more depending on
the expected intensity (the harshest and most viscous essential oils should not be used as they
may damage your diffuser).
-  Do not pour drops of refresher oils or essential oils into the container if
there is no water in it as this risks damaging the device.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oils or essential oils could prevent the diffusion and damage the
diffuser.
• Place the upper parts B then A back on the diffuser base D. Ensure that the upper part B is
lined up correctly with the water container, at the small notch. Wipe up any drops that may
accidentally have fallen outside the container.
• Do not move the diffuser once you have filled it.
D
STAGE 2
• Plug the appliance into a (mains) socket. Only use the electricity supply intended for this
purpose. Check that the electric plug is in conformity with your country's electricity installation.
If not, add a universal adapter to the plug (see non-exhaustive list of countries on page 5).
• In order to avoid any accident, make sure that the cable is not located in an area where people walk.
30 min
60 min
LIGHT Non sto p ON/OF F
30 min
60 min
LIGHT
LIGHT Non sto p ON/OF F
GB
O
CL
Aft
by
• s
• r
• e
con
• c
abs
up
tha
• u
ou
• u
• a
str
R
If
T
N
sw
M
in
In
30 min
60 min
Non sto p ON/OF F
Sh
Th
28/03/2017 09:34