Descargar Imprimir esta página

ESTEBAN CMP-121 Instrucciones De Uso página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
GB
4
30 min
60 min
Non sto p
LIGHT
ON/OF F
LIGHT
OPERATION AND MAINTENANCE INSTRUCTIONS
CLEANING
After each use, to avoid spotting and bad smells clean the appliance
by following these steps:
• switch it off and unplug from the mains
• remove the two upper parts A and B
• empty out the container to the right or the left to avoid any
contact with electrical parts
• clean the water container in order to remove all residues, for it use
absorbent paper impregnated with a mild detergent (soap, washing-
up liquid... Do not use aerosol sprays, solvents or abrasive products
that might damage the appliance). Then wipe it with a dry cloth
• use a soft cloth with a little of water if necessary to clean the
outside of the appliance
• use a wet cotton bud (water only) to clean the ceramic disk
• as this disk is very fragile and sensitive, make sure not to press too
strong and clean it after each use for longer operating life.
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
The light does not work
No mist when the appliance is
switched on
Mist stops while the diffuser is
in operation
Insufficient mist
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
CMP-121_NoticeDifMultiFonc_03-17_v2.indd 7
STAGE 4
• Press the "LIGHT" button:
1
press: the colours
st
scroll down.
2
nd
press: stop on the
current colour.
3
press: the luminous
rd
ambiance stops.
Causes
The appliance is not plugged in
Water level too low
Water level exceeds 100 ml
The ends of parts A and B are obstructed
Water level too low
Accumulation of water drops on the end of part B
The ceramic disk is dirty
An excess of Estéban refresher oils or essential oils has
been poured into the container
Accumulation of water drops on the end of part B
Misalignment of parts A and B
5
7 ml
30 min
60 min
LIGHT
Non sto p
ON/OF F
NEW USE
• see STAGE 1 of the section "STARTING THE DIFFUSER"
• replace the water in the container frequently to avoid any residue
that might damage the appliance
• empty out the liquid remaining after each use and clean the water
container and its ceramic disk each time you change the water or
fragrance, for an optimum fragrance.
LONG PERIOD WITHOUT USE
If the appliance is not going to be used during a long period, clean it,
dry it (by following the instructions in section "CLEANING"), and keep
it in a dry place.
Make sure that the power adapter is properly connected to the
appliance and fully plugged in to the wall socket
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the mist
Fill the water container
Switch off the diffuser, remove parts A and B then clean off the
accumulated water drops
Clean the ceramic disk as described in the "CLEANING"
instructions
Empty the appliance and clean it
Switch off the appliance, remove parts A and B then clean off
the accumulated water drops
Adjust the position of the two upper parts A and B
GB
STAGE 5
• The appliance stops
automatically if there is not
enough water: the lights
go out.
• Unplug the appliance, then
empty out the remaining
water to the right or
the left and clean it (refer
to the "CLEANING"
recommendations in the
operation and maintenance
instructions).
Solutions
28/03/2017 09:34
7

Publicidad

loading