Cautions When Operating The Rc Model; Troubleshooting - Carson Race Shark FD Indicaciones De Seguridad

CAUTIONS WHEN OPERATING THE RC MODEL

TROUBLESHOOTING

Problem
Model does not move
No control
The brushless motor suddenly
stops during normal operation.
GB // 16
Cause
Model has no contact with the water
Weak or no battery in the model
The overheat cut-out has stopped the model due
to overheating
Weak rechargeable battery/battery in transmitter
or model
The receiver is being affected by interference.
The functions of the speed controller have been
stopped by the integrated safety shut-off for low
battery voltage or overheating.
• Never run the model in crowded areas, near or toward people or
animals, to prevent property damage and/or personal injury.
• Never run the model on grassland. Twining grass may hinder
axle rotation and may cause motor heat buildup.
• Never run your model in flowing waters.
• Never run the model on public waterstreets, as it could endanger
the traffic.
Remedy
Make model into the water
Insert fully charged battery
Switch off the receiver. Allow the RC model to
cool down for approximately 30 minutes
Insert fully charged battery or new battery
Change location and start operation in another
area.
Replace the driving battery with a fully charged
battery or wait until the electronics have cooled
down.