Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 29)
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
F. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager. Click "Audio I/O", select
"Connector Settings"
detection", and save the change by clicking "OK".
System Panel Header
(9-pin PANEL1)
(see p.2 No. 18)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.2 No. 19)
Chassis Fan Connector
(3-pin CHA_FAN1)
(see p.2 No. 17)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.2 No. 6)
ASRock ConRoeXFire-eSATA2 Motherboard
This is an interface for front
panel audio cable that allows
convenient connection and
control of audio devices.
, choose "Disable front panel jack
This header accommodates
several system front panel
functions.
Please connect the chassis
speaker to this header.
Please connect a chassis fan
cable to this connector and
match the black wire to the
ground pin.
Please connect a CPU fan cable
to this connector and match
the black wire to the ground pin.
1 2 3 4
2 3
2 3
2 3
2 3
2 3
Publicidad
Tabla de contenido
