Installing Windows - ASROCK ConRoeXFire-eSATA2 Manual De Instrucciones

2.15.1 Installing Windows

2.15.1 Installing Windows
2.15.1 Installing Windows 2.15.1 Installing Windows 2.15.1 Installing Windows
RAID Functions RAID Functions RAID Functions RAID Functions RAID Functions
If you want to install Windows
RAID functions, please follow below steps.
STEP 1: Set up BIOS.
A. Enter BIOS SETUP UTILITY
B. Set "ATA/IDE Configuration" to [Enhanced], and then in the option "Configure
SATA as", please set the option to [RAID].
STEP 2: Make a SATA / SATAII Driver Diskette.
A. Insert the Support CD into your optical drive to boot your system.
B. During POST at the beginning of system boot-up, press <F11> key, and then a
window for boot devices selection appears. Please select CD-ROM as the boot
device.
C. When you see the message on the screen, "Do you want to generate Serial
ATA driver diskette [YN]?", press <Y>.
D. Then you will see these messages,
Please insert a diskette into the floppy drive.
WARNING! Formatting the floppy diskette will
lose ALL data in it!
Start to format and copy files [YN]?
Please insert a floppy diskette into the floppy drive, and press <Y>.
E. The system will start to format the floppy diskette and copy SATA / SATAII
drivers into the floppy diskette.
STEP 3: Use "RAID Installation Guide" to set RAID configuration.
Before you start to configure the RAID function, you need to check the installation
guide in the Support CD for proper configuration. Please refer to the document in the
Support CD, "Guide to SATA Hard Disks Installation and RAID Configuration", which is
located in the folder at the following path: .. \ RAID Installation Guide
STEP 4: Install Windows
After making a SATA / SATAII driver diskette and using "RAID Installation Guide" to set
RAID configuration, you can start to install Windows
system. At the beginning of Windows setup, press F6 to install a third-party RAID
driver. When prompted, insert the SATA / SATAII driver diskette containing the Intel
RAID driver. After reading the floppy disk, the driver will be presented. Select the
driver to install according to the mode you choose and the OS you
install. You may select: "Intel(R) 82801GR/GH SATA RAID Controller (Desktop ICH7R-
Windows XP/2000)" for Windows
Controller (Desktop ICH7R-Windows XP64)" for Windows
ASRock ConRoeXFire-eSATA2 Motherboard
2000 / XP / XP 64-bit With 2000 / XP / XP 64-bit With
2000 / XP / XP 64-bit With 2000 / XP / XP 64-bit With 2000 / XP / XP 64-bit With
®
® 2000 / XP / XP 64-bit on your SATA / SATAII HDDs with
Advanced screen
® 2000 / XP / XP 64-bit OS on your system.
®
®
XP/2000 or "Intel(R) 82801GR/GH SATA RAID
IDE Configuration.
2000 / XP / XP 64-bit on your
®
XP 64-bit.
®
3 3 3 3 3 3
3 3 3 3