Initial Installation; Menu Language - TechniSat TechniVision 22 ST Manual De Instrucciones

4

Initial Installation

After you have read through the safety instructions and connected the device according
to the instructions contained in section 4, you may proceed to switch on the device (as
described in section 6).
When you start the device for the first time, the start screen of the AutoInstall installa-
tion wizard appears. AutoInstall allows you to make the most important settings quickly
and easily.
The buttons on the remote control are marked to allow you to make the necessary set-
tings during each step of the installation process.
You can cancel the initial installation at any time by pressing the red function button.
Use the red function button to return to the previous installation step should you need to
correct any erroneous entries.
Use the green function button to confirm the settings that have been made and move on
to the next installation step.
If the initial installation is incomplete or if it has been cancelled, your device will start with
the standard presets.
The initial installation process shown here is only an example. The exact initial
installation process depends on the settings you select. Therefore, follow the instructions
displayed on the screen carefully.

Menu language

At the beginning of the installation process, AutoInstall displays the Menu
>
language selection screen.
Use the arrow buttons to highlight the desired menu language. Your selecting
>
is automatically entered into the settings as the preferred audio language.
Confirm by pressing the green function button.
>
10