Inserting And Changing The Batteries; Care And Cleaning; Safety Instructions - TechniSat TechniVision 22 ST Manual De Instrucciones

2.4 Remote control

2.4.1 Inserting and changing the batteries

> Open the cover of the battery compartment on the back of the remote control by
pressing down lightly on the mark.
> Insert the supplied batteries. Make sure to observe the correct polarity (the mark
can be seen in the battery compartment).
> Close the battery compartment.
2.4.2 Selecting the remote control options
Press the Digital button to switch the remote control to DVB mode or the TV
>
button to switch to TV mode.

2.5 Care and cleaning

Wipe the housing of the device using a soft, slightly damp cloth.
Do not use spray cleaner or aggressive chemical cleaning agents on the housing, as
these products could result in damage to the high-quality surface of the device.
To clean the display, make sure the device is switched off and then wipe the display with
a dry cloth or use the LCD panel cleaning set.
The LCD panel cleaning set is available for purchase from specialised dealers under the
following name and item number:
LCD panel cleaner

2.6 Safety instructions

For your own protection, you should read through these safety instructions carefully
before operating your new device.
The manufacturer assumes no liability for damage caused by improper use or failure to
comply with safety precautions.
- The device may only be operated under moderate ambient conditions.
- Place the device on a level surface in order to ensure sufficient ventilation.
- Do not place any burning objects (e.g. burning candles) on the device.
Item no. 0000/3830
5