TechniSat TechniVision 22 ST Manual De Instrucciones página 13

5 Operation
5.1 Switching the TV set on and off
Switching the device on
Switch the TV set on by pressing the On/Standby button on the remote control
>
or on the television.
Switching the device off
Switch the device off by pressing the On/Standby button on the remote control
>
or on the television.
The device is now in standby mode.
The LED lights up red.
5.2 Selecting digital TV and radio programmes
Please note that the remote control must be switched to DVB mode to select digital TV
and radio programmes (DVB-S and DVB-T). To switch the remote control to DVB mode,
press the Digital button.
5.2.1 Using the programme up/down buttons
Use the PROG +/- buttons either on the remote control to move up or down the
>
list one programme position at a time.
5.2.2 Using the number buttons
Use the number buttons to enter the desired programme number.
>
For example:
1
1, then 4
2, then 3, then 4
When entering programme numbers with more than one digit, you have about 3 seconds
after pressing each button to finish entering the entire number.
For example, if you would like to enter a one or two-digit number, you can speed up the
switching process by pressing and holding the last number.
for programme position 1
for programme position 14
for programme position 234
13