special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
• Never use metallic scouring pads or
abrasive products that could damage the
surface.
• Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
• To install the charcoal filter, the motor
anchorage is made to coincide with the
Electrical characteristics:
REFER TO RATING PLATE
Before seeking technical assistance carry out the following checks first:
Defect
The extractor does not
work
The extractor does not
blow
enough
vibrates
The lamps do not light
Height above gas hob: 75 mm minimum.
NEVER PLACE THE COOKER HOOD OVER
AN EYE-LEVEL GRILL.
Possible cause
The cable is not connected
No current is reaching the
plug
Filter saturated with grease
Outlet obstructed
or
Inadequate air conduit
Lamp broken
anchor points of the activated charcoal
filter and turn it clockwise.
• The carbon filter lasts from three to six
months depending on the particular
conditions of use.
• The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
• To replace exhausted filters with new ones,
withdraw the old one in the reverse order
to that of installation.
Solution
Connect the mains cable
Revise/repair the electricity circuit
Clean or substitute the filter
Eliminate obstructions
Contact the installer and follow instructions of
this manual
Contact the Customer Service
ILCOS D Code: DSL-9-S-500
This appliance must be connected by a
competent person, using fixed wiring via a
DOUBLE POLE SWITCHED FUSED SPUR
OUTLET.
EN
7