Maintenance - CEVIK PRO CA-PRO25SKIT Manual De Instrucciones

WHEN THE WORK HAS FINISHED:
ALWAYS DISCONNECT THE COMPRESSOR OFF FIRST THE BUTTON OF THE SWITCH,
THEN UNPLUG THE CABLE.
MAINTENANCE (THIS COMPRESSOR DOES NOT NEED OIL).
This compressor is self-lubricating, but it is not necessary to add oil.
•
• At the end of the work, empty the condensation of the air in the tank with the trap (4).
• Check for any unusual noise or vibration.
• Keep the air inlet filter clean and unobstructed, to avoid limiting air intake into the
compressor.
• In case of transport and / or storage, the compressor must not expose to temperatures
outside the range: + 5ºC to + 40ºC.
• In case of malfunction or breakdown, it is not a question of repairing unless you have
the appropriate technical qualifications and tools. Contact one of our technical services,
which on our website www.grupocevik.es.
• Inspect the air system for possible losses, at least once a month, applying soapy water
to all joints. Tighten those you discover that have losses.
• Clean the equipment with a soft brush or with a damp cloth, using a biodegradable
solvent. Do not use flammable liquids such as gasoline or alcohol.
• The air filter is placed in the air inlet of the compressor and helps prevent airborne
particles from entering the compressor and also significantly reduces noise. After being
used for long periods of time the filter must be cleaned. The dirty one makes the
entrance reduce the amount of air. For that reason the filter must be cleaned periodically
or replaced regularly:
- Remove the filter cover and replace the old one.
- Replace with a new filter and replace the cover.
26