Storage; Problem Solving - CEVIK PRO CA-PRO25SKIT Manual De Instrucciones

STORAGE.

If you need to store the equipment for a long time, then:
1. Turn the pressure switch to the off position.
2. Disconnect the equipment from the electrical contact.
3. Empty the tank through the safety valve.
4. Clean the compressor to remove impurities or dust.
5. Cover the compressor, so that dust does not enter.
6.
Place the compressor in a dry place. Do not place objects on top.
PROBLEMS SOLVING.
Item Description
1 Power switch does
not work.
2 It starts but it goes
very slow.
3 Loss of air pressure
in the tank or very
slow load.
4 Excessive heating.
5 Any other cause.
Possible cause
Loss of contact in some
electrical connection.
Pressure switch damaged.
The supply voltage is less
than 220V.
The tank trap is not closed.
Safety valve is open.
Dirty or clogged air filter.
Fans do not work. Replace
fans.
Clogged fans.
Unknown.
27
Solution
Check all electrical
connections.
Contact a Technical
Service.
Do not use a power
cord extension. Look for
an alternative energy
source.
Close the trap.
Check safety valve, if
necessary replace it.
Clean or replace it.
Replace fans.
Remove obstruction.
Contact one of our
technical services.