Clearing Blockages; General Maintenance - Ryobi RBL26BP Manual De Utilización

Follow the instructions on the machine or described earlier
in this manual.
TO STOP THE ENGINE
Press and hold the On/Off switch in "O" position until the
engine stops.
OPERATING THE BLOWER
Lift the running blower and place it on your back,
secure the chest strap. Put on the blower again. The
unit should be operated on the operator's right side
as shown.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
centre of a pile.
Operate power equipment at reasonable hours only —
not early in the morning or late at night when people
might be disturbed. Comply with the times listed in
local ordinances.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Operate blower at the lowest possible throttle speed
to do the job.
Check your equipment before operation, especially
the muffler, air intakes, and air filters.
Use rakes and brooms to loosen debris before
blowing. In dusty conditions, slightly dampen surfaces
when water is available.
Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
Use the wide sweeper nozzle for larger volume, so the
air stream can work close to the ground.
After using blowers or other equipment, clean up!
Dispose of debris properly.
CAUTION
Do not place blower on top of or near loose debris.
Debris may be sucked into blower intake vent resulting
in possible damage to the unit.
English (Original instructions)
MAINTENANCE
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.

CLEARING BLOCKAGES

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
LUBRICATION
All of the bearings in this tool are lubricated with a
the unit under normal operating conditions. Therefore, no
further lubrication is required.
CLEANING THE AIR FILTER SCREEN
screen clean.
14
WARNING
Check all nuts, bolts and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
If the blower looses power, or the engine speed
increases unexpectedly, there may be a blockage at
the intake.
Because this may require removal of the engine from
the backpack, you should take the unit to an authorised
service centre for investigation.
WARNING
Remove the air filter cover by pushing down on the
latch while gently pulling on the cover.
Brush the air filter screen lightly.
Reinstall the air box cover.