Spark Arrestor; Spark Plug - Ryobi RBL26BP Manual De Utilización

SPARK ARRESTOR

The silencer is equipped with a spark arrestor screen
inside silencer body. After extended use the screen can
become dirty and may need to have the silencer replaced
by an authorised servicing dealer.
WARNING
Never run the blower without the spark arrestor in
place. Failure to do so could result in a fire that could
cause serious personal injury.
CLEANING THE EXHAUST PORT AND SILENCER
Depending on the type of fuel used, the type and amount
of oil used, and/or your operating conditions, the exhaust
port and silencer may become blocked with carbon
deposits. If you notice low power from the blower, have
and silencer for carbon deposits. Removing the carbon
deposits should restore performance to the blower.
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be replaced
immediately. Failure to do so could result in a fire that
could cause serious personal injury.

SPARK PLUG

This engine uses a Champion RCJ-6Y with 0.63 mm
(0.025 in.) electrode gap. Use an exact replacement and
replace annually.
WARNING
Be careful not to cross-thread the spark plug.
Crossthreading will seriously damage the product.
TRANSPORTATION AND STORAGE (ONE
MONTH OR LONGER)
Stop the engine and allow it to cool before refuelling,
storing or transporting the machine
Drain all fuel and/or oil from tank into a container
approved for fuel. Run engine until it stops.
Clean all foreign material from the product. Store it in a
cool dry and well-ventilated place that is inaccessible
to children. Keep away from corrosive agents such
English (Original instructions)
15
as garden chemicals and de-icing salts. Do not store
outdoors.
Abide by all ISO and local regulations for the safe
storage and handling of fuel. Excess fuel should be
used up in other engine powered equipment.
For transportation, secure the machine against
movement or falling to prevent injury to persons or
damage to the machine.