NOTE: The following wires on the
18-pin harness are for future use
and are not to be connected at
this time.
Purple
Purple/Black
Green
Green/Black
From the 22-pin Chrysler harness:
• Connect the Yellow wire to the
radio's 12-volt battery or
memory wire.
• Connect the Black wire to the
radio's ground wire.
• Connect the White wire to the left
front positive speaker output of the
aftermarket radio
• Connect the White/Black wire
to the left front negative speaker
output of the aftermarket radio
99-6514 Interface
• Connect the Gray wire to the right
front positive speaker output of the
aftermarket radio
• Connect the Gray/Black wire to
the right front negative speaker
output of the aftermarket radio
• Connect the Green wire to the
radio's left rear positive
speaker output.
• Connect the Green/Black wire
to the radio's left rear negative
speaker output.
• Connect the purple wire to the
radio's right rear positive
speaker output.
• Connect the purple/Black wire
to the radio's right rear negative
speaker output.
• Plug the 18-pin harness into
the interface
99-6514B
Additional 12-pin harness
(ASWC harness)
This 12-pin harness is to be used
in conjunction with the ASWC (not
included). Please refer to ASWC
instructions for programming.
Installing the INtErFACE
• With all connections completed
to the aftermarket radio, plug the
22-pin harness into the vehicles
wiring harness.
• Plug the factory 44-way plug into
the back of the Metra kit. Please
note that some factory harnesses
are not long enough to re-route
around the aftermarket radio
and will need to route in front of
the radio mounting bracket on the
passenger side.
• Cycle the key, by turning the
ignition on for 30-seconds. Then
off and on again to test the radio.
5
testing the INtErFACE
• Turn the ignition on if not already,
and then turn the radio on to verify
that the radio works. Check
balance and fader controls for
proper operation.
• The potentiometer which is located
on the 16-pin side of the interface
is for future applications.