Set The Clock Manually - Explore Scientific WSH1008 Manual De Instrucciones

SET THE CLOCK MANUALLY

1. Press and hold [ MODE ] button to enter into
time setting.
2. The setting parameter will flash.
3. Press [ + ] button once, the figure will increase
1 unit. Press and hold the [ + ] button, the
figures will increase rapidly.
4. Press [ – ] button once, the figure will decrease
1 unit. Press and hold the [ – ] button, the
figures will decrease rapidly.
5. Press [ MODE ] button to confirm setting and
enter to next parameter.
6. Sequence of setting: Hour > Minute > Exit
7. If there is no action in 20 seconds,the setting
will be saved and you will exit the setting
mode.
8
°C/°F SETTING
Press [ - ] button to switch Celsius (°C) /
Fahrenheit (°F).