Temperature Alarm - Explore Scientific WSH1008 Manual De Instrucciones

TEMPERATURE ALARM

1. Press and hold [ + ] button to enter alarm
setting mode.
2. The setting parameter will flash.
3. Press [ + ] or [ - ] button to set the desired
data.
4. Press [ MODE ] to confirm setting and enter to
next parameter.
5. Sequence of setting: Upper limit On/Off >
Upper alarm temperature > Lower limit alarm >
Exit
6. If there is no action in 20 seconds,the setting
will be saved and you will exit the setting
mode.
9
Mould Warning
When the moldy definition is met, the LED
flashes once every 2 seconds, and [
appears. When it flashes, press any key to return
to the alarm point and stop all flashes until the
temperature leaves the range again.
EN
I T
]
DE
FR
ES