KIKKA BOO HOOD Instruccion De Uso página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
WARNING
READ THE INSTRUCTIONS CAREFULLY BEFORE USE AND SAVE THEM FOR FUTURE REFERENCE! THE CHILD CAN BE HURT IF YOU DO NOT OBSERVE THESE INSTRUCTIONS!
• This is a "Universal"child restraint,it is approved to Regulation N 44.04 series of amendments,for general use in vehicles and ii will fit most,bul not all, car seats.
• A correct fit is likely if the vehicle manufacturer has declared In the vehicle handbook that the vehicle is capable of accepting a "Universal"child restraint for this age group.
• This child restraint has been classified as"Universal"under more stringent conditions than those which applied to earlier designs which do not carry this notice.
• Only suitable if the vehicle is filled with 3-poinl safety belts,Approved to UN/ECE Regulation No. 16 or other equivalent standards.
• The instruction can be kept in the reserved place of the car seat within the usage period.
• Be sure that children are not left in their child restraint system unattended.
• The child restraint system should be changed when it has been subject to violent stresses in an accident.
• Any straps holding the restraint to the vehicle should be tight; Restraining the child should be adjusted according to the child's body, and should not be twisted.
• Any lap strap should be worn low down, so that the pelvis is firmly engaged, shall be stressed.
• Be sure any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured.
• The rigid items and plastic parts of a child restraint shall be so located and installed that they are not liable, during everyday use of the vehicle, to become trapped by a
movable seat or in a door of the vehicle.
• It is danger to make any alterations or additions to the device without the approval of the Type Approval Authority, and it is also danger not following closely the
installation instructions.
• It is extremely dangerous to use any load bearing contact points other than those described in the instructions and marked in the child restraint.
• The child restraint shall not be used without the cover; The seat cover should not be replaced with any other than the one recommended by the manufacturer.
• The child should be taken out from the car seat when it is being moved or adjusted.(except adjusting the headrest)
• The seat should be kept away from sunlight if the seat is not provided with a textile, otherwise it may be too hot for the child's skin.
• Please do not buy the second hand safety car seat. Because you may not know the using history of the car seat. It may have been in an accident or lack some parts.
• IMPORTANT-DO NOT use forward facing before the child's weight exceeds 9kg.
• The child car seat is suitable for weight categories 0+ to II (Group 0+,I,II),which means children with a body weight between O kg and 25 kg.
• Mass Group 0+:0-13kg Mass Group I: 9-18kg Mass Group II: 15-25kg
• This child car seat can be used with it's harness system for children of weight group O+, I. It must be secured with the belt fastener on the 3-point vehicle belt. For
children of weight categories II (15kg to 25kg) the harness system must be remove and the vehicle's 3-point belt system used to secure the child.
• Do not use child restraint system in seating positions where there is an air bag installed. Figure 2.1
I. PARTS:
1. Belt guide group II; 2. Headrest; 3. Shoulder pad; 4. Harness; 5. Comfor pad; 6. Harness adjuster lever; 7. Harness adjuster strap; 8. Lap belt routing soft; (Group 0m+); 9.
Incline adjuster botton; 10. Buckle; 11. Cotton pads; 12. Seat cover; 13. Adult belt route slots; 14. Child seat base 15. Harness connector; 16. Harness; 17. Metalic guide (Belt
guider for Group 0m+,I)
II. INSTALLATION GROUP O+
The harness system is only permitted for children of group O+, Which means from 0 kg to 13 kg to use.
2.1. SETTING THE SHOULDER BELT HEIGHT
Check whether the shoulder belts are set at the right height for your child. The shoulder belts should be fed into the belt slots that lie at shoulder height or just above. If the
height of your shoulder belts in child car seat is not fit for your child.
2.2. Adjust the height of the shoulder belts, please proceed as follows: Loosen the harness,turn the child seat to the back. Slide both of the harness off the harness
connector.
III. REVERSE INSTALLATION GROUP O+
Step 1.For Group O+,the safety position of the safety seat must only be used in the most reclined position(see Figure 3.1).The safety seat must never be used in any other
position(Figure 3.2).To adjust the reclining position of the safety seat,press the red incline adjuster botton (Figure 3.3). Untill you reach the required posilion(Fig.3.4).
Step 2. Secure the safety seat onto the car seat using the car seat belt.
Step 3. Pass the lap part of the seat belt under the base of the safety seat into the two points marked by a blue label and fasten the clip to the corresponding buckle.
Step 4. Pass the upper diagonal part of the belt in the metallic guide.
Step 5. Make sure that the belt is not twisted and strongly tightened.
Step 6. Tighten the car seat belt and be in a tight state to ensure safe and stable seat.
IV. REVERSE INSTALLATION GROUP I
Step 1. For Group I, ths safety position of the safety seat must only be used in the most reclined position (Figure 4.1). The safety seat must never be used in any other
position (Figure 4.2). To adjust the reclining position of the safety seat, press the red incline adjuster botton (Figure 4.3). Untill you reach the required position (Figure 4.4)
Step 2. Secure the safety seat onto the car seat using the car seat belt.
Step 3. Pass the lap part of the seat belt under the base of the safety seat into the two points marked by a blue label and fasten the clip to the corresponding buckle.
Step 4. Pass the upper diagonal part of the belt in the metalic guide.
Step 5. Make sure that the belt is not twisted and strongly tightened.
Step 6. Tighten the car seat belt and be in a tight state to ensure safe and stable seat.
IMPORTANT: DO NOT USE FORWARD FACING BEFORE THE CHILD`S WEIGHT EXCEEDS 9KG. SUGGEST TO CONTINUE USE REARWARD FACING WHEN CHILD`S WEIGHT LESS
THAN 18KG.
ENGLISH

Publicidad

Tabla de contenido
loading

Tabla de contenido