Operation - cecotec Conga EcoExtreme 3000 Manual De Instrucciones

ENGLISH
4. Attach the flexible tube to the air intake channel. Push until the tube locks with a click.
5. Insert the end of the handle of the flexible tube into the telescopic tube.
6. Extend the telescopic tube by sliding the plastic button and pulling from the upper part of
the tube. Adjust its length to your liking.
7. Insert the telescopic tube into the floor brush.
Unplug the appliance from the mains supply before assembling or removing any accessory.

3. OPERATION

1. Once all parts are in place, unwind a reasonable length of the cord and plug the appliance
into a grounded wall outlet. A yellow mark on the power cord marks the ideal length. Do
not pull the power beyond the red mark.
2. Press the on/off button to turn the vacuum cleaner on.
3. Suction power can be adjusted with the power controller on top of the appliance.
4. Once finished, unplug the appliance and use the cable retractor button to rewind the cord
into the appliance. Use one hand to press the button and guide the power cord with the
other.
Note: please note that there is a safety switch inside the vacuum cleaner to prevent the unit
from being run at high vacuum rates. If the vacuum is too high, the safety switch will be turned
on. In this case, it can diminish the vacuum rate and protect the motor from being damaged.
14 CONGA ECOEXTREME 3000
Power controller
Cable retractor button
Power button