Volume Knob/Tone Controls; Setup Options - Rockford Fosgate RAV Serie Instalación Y Operación

VOLUME KNOB/TONE CONTROLS

The Volume knob is a multifunction controller and
handles the Volume, Tone Controls, and Setup
Options, see below.
To Control Volume
1. Turn the VOLUME knob (Volume Outside) clockwise
to raise volume.
2. Turn the VOLUME knob (Volume Outside)
counter-clockwise to lower volume.
To Adjust Tone Controls
1. Press the SETUP button {Volume Center} (Set-Up) repeatedly
to cycle through BASS > MID > TREBLE > BALANCE >
FADER > AUX VOL > VOLUME.
2. Turn the VOLUME knob (Volume Outside) to increase,
clockwise, or decrease, counter-clockwise, the selected
function.
Source Tone Memory
Individual Bass & Mid settings are memorized for TUNER / DISC / AUX modes. A disc must be
inserted to adjust the settings for CD play mode.
NOTE: If no adjustment is made after 5 seconds, the MENU knob will revert to VOLUME mode.

SETUP OPTIONS

The list below shows the default Setup Options.
NOTE: These set-ups can be done easier when there is no disc in the source unit.
Selecting Options
1. Press and hold the SETUP button {Volume Center} (Set-Up)
for about 1 second until the first Option appears {INI/VOL}.
2. Press the SETUP button {Volume Center} (Set-Up) repeatedly
to cycle through Setup Options.
3. To change an Option, press the UP or DN {Down} Button
( or ).
4. To store, wait 5 seconds and the Display will return to the
last Mode shown.
• INI/VOL (Initial Volume) {0-30} — Use the volume control to adjust. Sets the maximum Initial
Volume when the unit turns on. If the volume setting was lower than the initial volume setting
when the unit is turned off, then the lower volume will be used at turn on. If the volume setting
was higher than the initial volume setting, then the initial volume setting is used at turn on. This
feature prevents accidental high volume turn on as well as allows
high volume settings to be retained in case a preamplifier is the
system's main volume control. Default is 15.
• CONTRAST (-5 to +40) — This sets the contrast of the display.
Use the Up and Down buttons to adjust (
remote). Default is +9.
or on the
O
PERATION
Remote
Volume Control
Press
Press
Press &
Hold
Press & Hold
Remote
– B
ASIC
13