Iso-Din Mount; Wiring The System - Rockford Fosgate RAV Serie Instalación Y Operación

• Bend Appropriate Tabs on all sides of the installation sleeve. See Installation Sheet.
• Install Source Unit by sliding unit into installation sleeve until it clicks into place.
• Mount Back Strap securely behind the instrument panel to prevent source unit vibration.
• Back strap Screw should be 6mm max (use supplied screw).
• Connect Antenna to antenna jack on rear of source unit.
Removal;
• Disconnect Back Strap from rear of radio (if used).
• Remove Trim Piece from front of radio.
• Insert Release Keys into left and right sides of source unit to
disengage locks.
• Remove Source Unit from installation sleeve with release keys.

ISO-DIN MOUNT

Installing;
• Remove Trim Piece and Installation Sleeve from source
unit.
• Factory Bracket should align with two mounting holes
on each side of source unit.
• ISO Screws should be 6mm max (use supplied screws).
• Connect Antenna to antenna jack on rear of source
unit.
• Install Source Unit into instrument panel.

WIRING THE SYSTEM

NOTE: This unit has been specifically designed to be used with an external amplifier with RCA
input connections for the best quality performance.
Also, this unit requires an accessory video screen for DVD and advance menu viewing.
NOTE: See diagram on following page to help you connect your system.
CAUTION: If you do not feel comfortable with wiring your new source unit, please
!
see your local Authorized Rockford Fosgate Dealer for installation.
CAUTION: Before installation, disconnect the battery negative (-) terminal to
!
prevent damage to the unit, fire and/or possible injury.
1. Install the 16-Pin Power Harness by connecting the corresponding wires to the electrical and
audio system. Solder and heat shrink all connections for a reliable installation. For each
connection, cut a 1" piece of heat shrink tubing and slide over one of the wires. Strip each wire
3/8" then twist together and solder. Slide the tubing over the connection and shrink the tubing
with a hot air gun until no bare wire is exposed.
2. Connect the BLACK (Ground) wire to chassis ground. Prepare the chassis ground by scraping
any paint from the metal surface and thoroughly clean the area of all dirt and grease. Strip the
end of the wire and attach a ring connector. Fasten the wire to the chassis using a non-anodized
screw and star washer.
3. Connect the YELLOW (Back Up) wire to a source of constant +12V (for retaining memory on
user-programmed functions). The source should always have +12V, even when the ignition is off
and the car is not running.
4. Connect the RED (ACC +B) wire (Ignition) to a source of switched +12V (is on only when
ignition key is in "accessory" or "run" position). The switched signal is usually taken from the
ACC (accessory) position of the ignition. If the vehicle does not have an ACC position, connect
the wire to the switched ON position of the ignition.
Factory Bracket
Screw
I
NSTALLATION
Release Key
Dash
Trim
7