Operation - Desa GWRN10 Manual De Instrucciones

INSTALLATION
Continued
Test Pressures Equal To or Less Than
1/2 PSIG (14" WC)
1. Close equipment shutoff valve (see Figure 14).
2. Pressurize supply piping system by either
opening propane/LP supply tank valve
for propane/LP gas or opening main gas
valve located on or near gas meter for
natural gas or using compressed air.
3. Check all joints from gas meter for natural
gas (see Figure 15) or propane/LP supply
tank for propane/LP gas, to equipment
shutoff valve (see Figure 16). Apply a
noncorrosive leak detection fluid to all
joints. Bubbles forming show a leak.
4. Correct all leaks at once.
PRESSURE TESTING HEATER GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure 14).
2. For natural gas open main gas valve
located on or near gas meter. For pro-
pane/LP gas open propane/LP supply
tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from equipment shutoff
valve to thermostat gas valve (see Figure
15 or 16). Apply a noncorrosive leak de-
tection fluid to all joints. Bubbles forming
show a leak.
5. Correct all leaks at once.
6. Light heater (see Operating Heater).
Check all other internal joints for leaks.
7. Turn off heater (see To Turn Off Gas to
Appliance, page 14).
8. Replace front panel.
Equipment
Shutoff Valve
Figure 14 - Equipment Shutoff Valve
Gas
Meter
Figure 15 - Checking Gas Joints for
Natural Gas
12
Propane/LP
Supply
Tank
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
B. BEFORE LIGHTING smell all around
Open
Closed
C. Use only your hand to push in or turn
Control
Valve
Location
D. Do not use this appliance if any part
Equipment
Shutoff
Valve
www.desatech.com
Figure 16 - Checking Gas Joints for
Propane/LP Gas

OPERATION

FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not fol-
be lighted by hand. When lighting the pi-
lot, follow these instructions exactly.
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don't try to repair it, call a qualified
service technician. Force or attempted
repair may result in a fire or explosion.
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
Control
Valve
Location
Equipment
Shutoff
Valve
107902-01L