Turning Power On/Off; Turning On The Main Power - Sharp PN-R706 Manual De Instalación

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.

Turning on the main power

Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main plug.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
[PN-R706/PN-R606]
[PN-R556/PN-R496/PN-R426]
Power LED
Status
Green lit Power on
Orange lit Power off (Standby mode)
Green flashing Input signal waiting mode
Turning Power On/Off
Power button
Power LED
Power button
Status of the monitor
How to pull out the power LED/remote control sensor
Pull out
Lever
Power LED / Remote control sensor
• Slide the lever on the rear of the monitor to pull out the power
LED/remote control sensor.
Press the power LED/remote control sensor directly to store it
inside the monitor.
nDate/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/ /
01 / 01 / 20 17
OK:[ENTER] CANCEL:[RETURN]
1. Press or to select the date and time, and press
or to change the numerical values.
2. Press the ENTER button.
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
• Set the date in "Month/Day/Year" order.
• Set the time on a 12-hour basis.
The clock is maintained by the internal battery.
•
If you already set the time but the date/time setting
•
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact an
authorized SHARP servicing dealer or service center for
assistance with battery replacement.
• Estimated service life of the internal battery: About 5
years (depending on monitor operation)
The initial battery was inserted at the factory when the
•
monitor was shipped, so it may run out of power before
its expected operation life.
Store
: :
12 : 00 AM
7
E