Denon DCD-485 Instrucciones De Operación página 14

ENGLISH
REMOTE CONTROL UNIT RC-266
Track Selection
Use the number buttons (1~10 and +10) while programming
and to access a desired track almost instantly.
The automatic search buttons (
advance or return from the current track to the next track.
Call Button (CALL)
5
Open/Close Button ( OPEN/CLOSE)
Auto Space Button (A. SPACE)
Auto Edit Button (A. EDIT)
1
Play Button ( )
3
Pause Button ( )
2
Stop Button ( )
Manual Search Reverse Button (
Manual Search Forward Button (
Checking Programmed Contents
By pushing the CALL button on the remote control unit,
programmed contents will be displayed. Tracks entered into
the memory, will be displayed starting from the first track
entered and will advance one step at a time each time the
CALL button is pushed.
Notes on Operation
• Do not push identical buttons on the CD player and remote control
unit simultaneously as this may cause malfunction.
• The remote control unit may be difficult to operate if the remote
control sensor is exposed to strong light, such as direct sunlight or
light from fluorescent lamps or if there are obstacles between the
remote control unit and the sensor.
• Direct track selection
Using the number buttons (1~10 and +10), tracks can be directly
assigned for playback.
14
8 9
and ) are best used to
6
)
7
)
Setting to the Program Mode
• For programming operation, push the PROG button then the
number buttons (1 ~ 10 and +10).
• The remote control unit is normally set to the direct mode.
• Track selection while programming
Push the PROG button and then the track numbers you wish to
enter into the memory.
Example: PROG / 3 / +10 & 1 / 5....
(Tracks 3, 11, 5 and so on are entered into the
memory.)
Memorized tracks are erased by pushing DIRECT button in any
time.
• Correct use of the number buttons
Direct selection of single-digit tracks is easy by just pushing the
desired number button. For tracks with numbers from 11 and on,
first push the +10 button and then a single-digit button. E.g., to
select track 22, push the +10 button twice and then push the 2
button.
Output Level Adjustment
The output level of the Line Out jacks and the Headphone
output jack can be changed.
The output level of the Digital Out jack cannot be changed.
•
Pushing the Volume Up ( ) button during play will increase the
output level.
ª
Pushing the Volume Down (
level.
Program Button (PROG)
Direct Search Button (DIRECT)
Number Buttons (1~10)
+10 Button (+10)
Dimmer Button (DISPLAY)
Time Mode Button (TIME)
Volume Up Button (
Repeat All Button (ALL)
A-B Repeat Button (A-B)
Volume Down button (
Automatic Search Forward Button (
Automatic Search Reverse Button (
) button will decrease the output
•
)
ª
)
9
)
8
)