Cadac GRILLO CHEF 2 Manual De Instrucciones página 5

General
• Once the appliance is lit, the fl ame intensity may be adjusted by turning the valve knob anti-clockwise to reduce the fl ame, or
clockwise to increase the fl ame.
• The fully closed position is at the furthest clockwise position. To rotate the valve from the fully closed position it is necessary to fi rst
depress the knob just enough to move out of the lock mechanism. While holding the knob in, turn it in an anti-clockwise direction.
Once the spindle has moved out of the lock position it is no longer necessary to keep the control knob depressed and it can be rotated
freely to the desired fl ame setting.
• The fl ame may be observed through the Inspection Hole provided for this purpose on the side of the fat pan.
• When cooking food with a high fat content, fl aring may occur if the selected heat setting is too high. Should this happen, turn the heat
down until the fl aring ceases.
• Do not move the appliance when in use as, apart from being an unsafe practice, to move the appliance whilst lit, may cause fl aring.
• After use, fi rst close the valve on the gas container (where applicable). When the fl ame has extinguished, close the valve on the
appliance by pushing in and turning the Control Knob fully clockwise.
4. Fitting and Changing the Gas Cylinder
• After use, turn off the control knob to the off position ("•" - turn fully clockwise) and close the gas cylinder valve.
• Ensure that the gas cylinder is fi tted or changed in a well-ventilated location away from any source of ignition, such as naked fl ames
and away from other people.
• Do not smoke while changing the cylinder.
• When you need to replace your empty cylinder, make sure that the gas is closed at the cylinder valve.
• Remove the regulator from the empty cylinder.
• Avoid twisting the hose whilst connecting the regulator to the new/replacement cylinder.
• Blow out any dust from the cylinder opening to prevent possible blockage of the jet.
• Place the full cylinder in its allocated space and attach the regulator connection to the cylinder.
• Ensure that a complete gas seal has been made (check for the smell of gas around the connection joint). Do not check for leaks with a
naked fl ame. Use warm soapy water only, applied to the joints and connections of the appliance. Any leakage will show up as bubbles
around the leakage area. If you are in doubt, contact your nearest stockist.
5. Cleaning
• Allow the appliance to cool down before you clean it.
• Use a damp cloth wrung out in a solution of soapy water to clean the exterior and cylinder storage area.
• The grill plate is coated with a tough durable non-stick coating that has been used with great success on some of the best cookware in
the world. Never the less, taking care of it can help you to enjoy extra years of healthy, easy, non-stick cooking.
• Whilst the non-stick coating is very durable, it can easily be damaged by the use of metal cooking utensils. It is therefore
recommended that only plastic or wooden utensils be used when cooking.
• Always allow the grill plate to cool before immersing it in water.
• Make sure that no water gets onto the burners or pilot/light area. Wipe the appliance completely dry before use.
• Do not use abrasive cleaners as they may damage the surfaces.
• Clean the appliance after each use. After cleaning recondition the surface with a light wipe of oil.
• Do not use any high-pressure steam equipment or a water jet to clean the appliance.
• Remove the fat from the moat of the Fat Pan.
• Note: For stubborn stains, oven cleaner may be used.
6. Combos
3 3
GB