Placing Tool In Service - Facom DF.17 Guía De Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection when operating or
performing maintenance on this tool.
Air powered tools can vibrate in use. Vibration,
repetitive motions or uncomfortable positions may be
harmful to your hands and arms. Stop using any tool if
discomfort, tingling feeling or pain occurs.
Seek medical advice before resuming use.
Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool, or before performing any
maintenance on this tool.
LUBRICATION
FACOM NS.557-04
Always use of an air line lubricator with these tools. We recommended the
following Filter-Lubricator-Regulator Unit: FACOM N.558D.
After each eight hours operation, unless the air line lubricator is used, detach
the air hose and inject about 1-1/2 cc of oil into the inlet busching.
After each forty-eight hours of operation, or as experience indicates, remove
the Oil Chamber Plug and fi ll the impact mechanism oil chamber with the
recommended oil FACOM NS.557-04.
NU-DF.17_0217.indd 8
WARNING LABEL IDENTIFICATION
WARNING
WARNING
WARNING

PLACING TOOL IN SERVICE

WARNING
Always wear hearing protection when operating
this tool.
Do not carry the tool by the hose.
Keep body stance balanced and fi rm. Do not overreach
when operating this tool.
Operate at 90 psig (6.2 bar/ 620 kPa) Maximum air
pressure.
Do not use damaged, frayed or deteriorated air hoses
and fi ttings.
WARNING
WARNING
WARNING
WARNING
WARNING
05/09/2017 15:54:18