Cafe CVE Serie Manual De Instrucciones página 34

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
12
REPLACE FREEZER DRAWER
(on some models)
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to secure
the door before lifting.
1. Pull the lower basket slide mechanism to full
extension with both hands.
notches on the slide mechanisms.
NOTE: Place one side in first, then align the other
side.
3. Replace the attachment screws and torque the
screws to 65 in-lb (7.34 N-m).
RE-INSTALL PIZZA TRAY AND
13
LOWER FREEZER BASKET (on
some models)
2. Check for smooth operation of baskets.
wheels onto the top of the track mounted to the
basket sides.
49-1000329 Rev. 1
14
and reinstalling the door. Failure to follow these
instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and
property damage.
A single person lift could cause injury. Gain
assistance when handling, moving, or lifting
hook and slide refrigerator doors.
mechanism notch
1. Reinstall lower hinges first (if necessary) and
2. With the door at 90° to the front of the case,
3. Reinstall the center hinge per step #1 above.
4. Remove the tape.
5. Open the lower right-hand door 90°.
6. Connect the two harnesses.
7. Replace both lower hinge covers (if necessary).
REINSTALL LOWER LEFT AND
RIGHT-HAND DOORS
(on some models)
WARNING
Follow all steps for removing
CAUTION
Lifting Hazard
and small screw to 25 in-lbs (2.82 N-m). Rotating
the screw by 1/3 turn after it is flush with mating
surface will achieve these torques.
lower the refrigerator door onto the lower
hinge, carefully pulling the harness through
the right-hand hinge. Close the door and tape
closed.
33