Installing The Refrigerator - Cafe CVE Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION
Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Do not install the refrigerator where the
temperature will go above 100°F (37°C) because
it will not perform properly.
Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
REMOVING THE REFRIGERATOR
DOORS
IMPORTANT NOTE:
(943 mm) deep (refer to chart on previous page).
Doors and passageways leading to the installation
in order to leave the doors and handles attached
to the refrigerator while transporting it into the
installation location. If passageways are less
handles can easily be scratched and damaged.
The top cap and doors can be removed to allow
the refrigerator to be safely moved indoors. If
start with Step 1.
If it is not necessary to remove doors, skip to Step
11. Leave tape and all packaging on doors until the
refrigerator is in the final location.
NOTE:
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
28
1
REMOVE THE REFRIGERATOR
AND FREEZER DOOR HANDLES
(if necessary)
Handle design varies; however installation is the
same.
1. Tighten/loosen the handle to/from the door by
film on door until installation is finished.
2. If handle mounting fasteners need to be
Mounting
Fasteners
Mounting
Fasteners
49-1000329 Rev. 1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cqe serieCve28dpCve28dm

Tabla de contenido