Tightening The Threaded Fastener In "Adaptive" Operating Mode - Hilti SI­-AT­-A22 Manual De Instrucciones

3. Press the OK button.
▶ A black background appears behind the option you selected.
4. Use the arrow buttons to select the desired setting.
5. Press the OK button.
▶ The selected setting appears in the selection frame.
6. Repeat the last 3 steps as necessary to make other changes.
7. Lock the torque module. → page 5
5.7.2 Setting the operating mode by scanning the barcode or QR code
1. Unlock the torque module. → page 5
2. Press the "Scan" button.
▶ The scanner is activated and the
ready.
3. Hold the module facing the barcode or QR code at a distance of approx. 15 centimeters (6"), so that the
code is inside the frame projected by the scanner.
▶ The LEDs show green.
▶ The confirmation tone sounds.
▶ The operating mode for the product to be tightened appears on the display.
▶ The LEDs flash red.
▶ The warning tone sounds.
appears on the display (code could not be read or was not recognized).
▶
▶ Press the "Scan" button and scan the code again.
Operating parameters for the product to be tightened might not yet be available in the
torque module's memory. If the product is SI-AT-compatible, you can scan the QR code
of the corresponding product in the SI-AT-A22 operating instructions. In this way you
can write the operating parameters into the memory of the SI-AT module. The operating
parameters for the product can also be uploaded to the torque module via USB with the
AT Documentation Software. Regularly check for updates to the software installed in the
torque module in order to ensure that the latest parameters are always applied.
4. Lock the torque module. → page 5
5.8

Tightening the threaded fastener in "Adaptive" operating mode

Before using the torque module, make sure that the threaded fastener to be tightened is correctly
installed. Follow the instructions in the operating instructions of the product to be tightened and the
information on checking the fasteners.
1. Select the "Adaptive" operating mode.
2. Set the forward/reverse switch to the "Forward" position.
3. Install a suitable accessory tool on the impact wrench and engage the product to be tightened.
4. Press the control switch and hold it down until the torque module returns one of the following feedback
signals:
Result 1 / 4
• The symbol indicating "Tightening completed
successfully" is displayed.
• The LEDs show green.
• The confirmation tone sounds.
The fastener was tightened correctly. Proceed with
the next fastener of the same type.
*2124681*
symbol appears on the display to indicate that the scanner is
2124681
5
English 9