Klippan kiss Manual De Instrucciones página 20

Fitting instruction – Fitting using ISOFIX mounts
10. Fold down the supporting leg before placing the base in the car. If you fit the Kiss on the front seat in your car. The backrest
of the car seat must be in upright position.
11. Place the base in the required location in the car. When fitting the seat in the rear, the seat in front of it may need to be
moved forwards slightly. Continue at illustration 12 if you want to fit using ISOFIX, illustration 21 if you want to fit using a
three-point belt, and illustration 27 if you want to fit using two-points belt
12. The instruction manual for your car will tell you where to find the ISOFIX mounts in your car. Lift up the red catch (A) and
move the base forward (B), so that the yellow arrows point are at one another (C).
13. Push the base on the ISOFIX MOUNTS. If you find it difficult to get at the mounts, use the ISOFIX guides included ( black
plastic parts inserted around the ISOFIX mounts) for easier access
14. Make sure that the indicator is green on both sides. This ensures that the base is locked properly.
15. Push the base onto the car seats backrest so that the base locks (click) properly. The black frame must be tight to the car
seat backrest.
16. Adjust the height of the supporting leg by pulling out the red button. Make sure that it sits firmly on the floor. The
supporting leg must be adjusted so that the base rests on the seat. Move on to fitting of the seat itself, illustration 31.
Fitting instruction – Removal from ISOFIX mounts
17. NB: Removal Remove the supporting leg from the floor in order to facilitate removal of the base. Push down the red catch
and release the pretension from the base.
18. NB: Removal Lift the ISOFIX button on both sides and pull in the direction of the arrow so that the indicator is red
Fitting instruction – Fitting using a three-point belt
19. Fold down the supporting leg before placing the base in the car. If you fit the KISS seat on the front seat of the car, the
backrest of the car seat must be in upright position
20. Place the base in the required location in the car. When fitting the seat in the rear.the seat in front of it may need to be
moved forwards slightly.
21. Make sure that the blue arrows in the bottom of the base are located directly in front of one another as shown in (A).
Adjust the arrows if so required; lift up the red lever in bottom of the base as shown in (B) in order to adjust the position
forwards or backwards as shown in (C)
22. Click the car´s seat belt into its lock. Pull the lap belt behind the frame.
23. Thread the lap belt through the blue mounts on both sides.
24. Open the blue belt clip (A) and thread the car seatbelt diagonal part through the blue mount (B) and through the clip (A)
and through the mount (C)
25. Push down the base and tighten the seat belt properly. Make sure that the belt keeps the base on place. Lock the blue clip
and make sure that it is properly locked.
26. Adjust the height of the supporting leg by pulling out the red button. Make sure that it sits firmly on the floor. The
supporting leg must be adjusted so that the base rests on the seat. Move on to fitting of the seat itself, illustration 31
20