Kenmore A06161001A Instrucciones De Instalación página 6

Installation Requirements
Drain system requirements
1 Drain capable of eliminating 17 gals (64.3 L) per
minute.
2 A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
3 The standpipe height above the fl oor should be:
Minimum height: 33 in. (84 cm)
Maximum height: 96 in. (244 cm)
NOTE
For installations requiring a longer drain hose, have
a qualifi ed technician install hose P/N 134592700,
available from Sears Parts & Repair. Call 1-800-4-MY-
HOME. For drain systems in the fl oor, install a syphon
break kit available from Sears Parts & Repair.
Exhaust system requirements
Use only 4 inch (102 mm) diameter rigid or fl exible
metal duct and approved vent hood which has a swing-
out damper(s) that open when the dryer is in operation.
When the dryer stops, the dampers automatically close
to prevent drafts and the entrance of insects and rodents.
To avoid restricting the outlet, maintain a minimum of 12
inches (30.5 cm) clearance between the vent hood and the
ground or any other obstruction.
WARNING
FIRE HAZARD
Failure to follow these instructions can create excessive
drying times and fi re hazards.
The following are specifi c requirements for proper and
safe operation of your laundry center.
WARNING
FIRE HAZARD
Do not install a clothes dryer with fl exible plastic or
metal foil venting materials. Flexible venting materials
are known to collapse, be easily crushed and trap lint.
These conditions will obstruct clothes dryer airfl ow and
increase the risk of fi re.
If your present system is made up of plastic duct or metal
foil duct, replace it with a rigid or semi-rigid metal duct.
Also, ensure the present duct is free of any lint prior to
installing dryer duct.
96"
(244cm)
max.
33"
(84cm)
min.
Correct
Incorrect
6