SANUS VuePoint F11c Manual De Instrucciones página 13

3. Drill pilot holes.
IMPORTANT: Pilot holes must be drilled to a depth of 63.5 mm (2½ in.), using a 3 mm (1/8 in.) diameter drill bit.
16
4. Tighten the lag bolts
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
only until they are pulled firmly against the wall plate
14
15
.
4
63.5 mm
(2½ in.)
3 mm
(1/8 in.)
16
15
STEP 2
13