Passport P-10W UHF Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Connecting the line output to another piece of equipment
The 1/8" line output is available to send the audio signal from the P-10W
UHF to another piece of equipment. For example if you want to record a
presentation (or you singing!) you can connect this output jack to the input
jack of a cassette recorder.
AC to DC power adapter
A power adapter is supplied with your P-10W UHF. This adapter is used to
recharge the battery. It is not designed to power the P-10W UHF from an
AC source. Make sure the P-10W UHF is turned off when recharging the
battery.
The power adapter converts AC power to DC power. The output of the power
adapter is 18V DC. (The inner section of the connector is positive.)
Charging the Battery
Plug the barrel end of the cord into the DC power input jack (N) and plug
the AC end into your AC power source. Charging will begin immediately and
the Battery Charge Indicator (K) will show a blinking green light.
Battery Charge Indicator. Red light indicates battery is low and needs
charging. Green, blinking light indicates charging in progress. Solid green
light indicates battery is fully charged.
If the indicator does not immediately start to blink green, it may be due to
excessive power drain of the battery. This is normal. The indicator should
begin to blink after 10 to 15 minutes. If the battery charge indicator fails to
light, it may be due to a faulty battery.
The P-10W UHF has an auto turn-off protection circuit. When the battery
charge is weak, the unit will automatically turn off to prevent damaging the
battery. If this happens, turn off the unit and recharge the battery.
Replacing, or using a second Battery
With proper care and charging, it is unlikely that it will be necessary to
replace the battery in the P-10W UHF . If you plan on using the P-10W UHF
for extended periods of time, you may want to purchase a second battery.
The battery is a standard 12 volt 2.9 amp gel cell and is available from Fender
directly, for from Authorized Fender Audio dealers. (P/N 005-7535-000).

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

P-10we uhf

Tabla de contenido