Passport P-10W UHF Manual Del Usuario página 8

Wireless Belt-Pack Transmitter
Plug either the Headset or Lavaliere microphone into the belt-pack transmitter
then tighten the threaded collar to ensure a secure connection.
Turn on the P-10W UHF.
Turn on the wireless belt-pack transmitter.
Proceed to "Scanning for a clear channel" section below.
Scanning for a clear channel:
There are 16 channels available. The receiver will scan through the channels
in the following order:
To scan for a clear channel:
1. Press and hold the CHANNEL SCAN (F) button on the P-10W UHF for 1
second.
2. The receiver module will automatically scan the channels and switch to
the first available clear channel. The new channel will be shown on the
CHANNEL indicator (C).
Note: If the current channel is clear, the receiver will not change channels. The
channel number shown in the CHANNEL indicator will remain the same, but it
will blink for 5 seconds to acknowledge that a scan was completed.
Manually forcing a channel change:
To manually force a channel change, press the CHANNEL SCAN (F) button a
second time while the CHANNEL indicator (C) is blinking. This will force the
receiver to change to the next available clear channel.
Programming the transmitter (wireless microphone and belt-pack):
To program the UHF Handheld wireless microphone or the UHF belt-pack
transmitter:
1. Make sure the microphone or belt-pack transmitter is on, then point the
HOT SPOT on the transmitter at the HOT SPOT on the P-10W UHF.
Note: The HOT SPOT is located on the end cap of the UHF Handheld wireless
microphone, and on the battery cover of the UHF belt-pack transmitter.