Passport P-10W UHF Manual Del Usuario página 9

2. Press the PROGRAM MIC button on the receiver module.
During programming, the CHANNEL indicator on the P-10W UHF will blink
and the LED on the transmitter will light up.
When programming is complete (usually about 1 second), the CHANNEL
indicator will stop blinking and the LED on the transmitter will go dark. The
transmitter is now set to the new channel.
TIP: To verify the link on the new channel, check the POWER LED on the P-10W
UHF. It will be green if it is receiving a good RF signal from the transmitter. If it
is still red, check the transmitter's battery first. Then repeat the channel scan and
transmitter programming process.
The wireless microphone included with your P-10W UHF is a high quality
microphone designed for use with voice or instruments. The receiver is built
into the P-10W UHF, and the transmission range (how far away you can move
the microphone away from the receiver) is well over 100 feet. Keep in mind
that many household and office appliances, as well as overhead florescent
lights, or lights on dimmer switches can cause interference with your wireless
transmission. If this happens, simply move the P-10W UHF or move the
microphone to an area where you receive clear transmission. In most cases,
this should be no more than a few feet.
Using the secondary 1/4" microphone input
You must use a microphone that has a cable with a 1/4" connector. Plug the
1/4" end of the mic cable into the 1/4" Input Jack (G) on the P-10W UHF.
Adjust the 1/4" input level control (J) to desired volume.
Connecting another audio source to the P-10W UHF
The 1/8" Auxiliary input jack (M) is available to connect a CD, Cassette player,
or MP3s to the P-10W UHF.
Connect the device's audio or headphone output to the 1/8" Auxiliary input
jack (M) on the P-10W UHF. Make sure that the CD, cassette, or MP3's volume
is turned down before plugging into the P-10W UHF's auxiliary input jack.
Turn the Volume Control (H) clockwise to turn on the P-10W UHF, and adjust
to the minimum volume setting. Slowly turn up the volume on the auxiliary
device.