Publicidad
Idiomas disponibles
Idiomas disponibles
Images may slightly differ from the real product.
LCD Description
On key. Press (and hold down) for several seconds until the system beeps twice.
Off key. Press (and hold down) for several seconds until the system beeps twice.
Press (with the UPS on) and hold down for several seconds until the UPS beeps twice to start
the self-test mode. The word Testing will flash until the test completes.
Press and hold down for one second with the UPS on to change the displayed parameters (Vin,
Fin, Vout, Fout, % Load, Aout, Vbatt)
When alarm buzzers sound, press to mute the UPS.
[Normal Mode LED]: On-line operating mode indicator. Off when off-line.
[Battery Mode LED]: Battery operating mode indicator due to the lack or unsuitability of the
mains. (Normal Mode LED off,
on LCD).
[Fault LED]: On when faults occur.
[Bad/Weak Battery LED]: On when the battery pack is dead or faulty.
The device is in AC mode (Normal Mode LED = Green light).
The device is in Battery mode (Battery Mode LED = Yellow light). The device beeps every 2
seconds (approximately).
Overload condition.
Operating problem. An ID code may appear on the display. Contact customer service.
The device is operating in Service/Calibration mode.
Active output outlets are displayed. These are programmable in the 3KVA model
(17NXGCON12001). Therefore, when some of the set conditions are exceeded, they may no
longer be powered to store residual power for critical loads.
Power Flow Chart: UPS operating status is indicated.
Publicidad
