Kenwood HF Guida Rapida página 2

Firmware Copyrights
The title to and ownership of copyrights for firmware embedded in KENWOOD product memories are reserved for JVC KENWOOD
Corporation.
Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for countries that have
adopted separate waste collection systems)
Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste.
Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and
their waste byproducts.
Contact your local authority for details in locating a recycle facility nearest to you.
Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and
the environment.
Please observe the following precautions to prevent fire, personal injury, and transceiver damage:
•
Connect the transceiver only to a power source as described in this manual or as marked on the transceiver itself.
•
Route all power cables safely. Ensure the power cables can neither be stepped upon nor pinched by items placed near or against the
cables. Pay particular attention to locations near AC receptacles, AC outlet strips, and points of entry to the transceiver.
• Take care not to drop objects or spill liquid into the transceiver through enclosure openings. Metal objects, such as hairpins or
needles, inserted into the transceiver may contact voltages resulting in serious electrical shocks. Never permit children to insert any
objects into the transceiver.
• Do not attempt to defeat methods used for grounding and electrical polarization in the transceiver, particularly involving the power
input cable.
•
Adequately ground all outdoor antennas for this transceiver using approved methods. Grounding helps protect against voltage surges
caused by lightning. It also reduces the chance of a build-up of static charge.
ELECTRIC SERVICE EQUIPMENT
• Minimum recommended distance for an outdoor antenna from power lines is one and one-half times the vertical height of the
associated antenna support structure. This distance allows adequate clearance from the power lines if the support structure fails for
any reason.
•
Locate the transceiver so as not to interfere with its ventilation. Do not place books or other equipment on the transceiver that may
impede the free movement of air. Allow a minimum of 10 cm (4 inches) between the rear of the transceiver and the wall or operating
desk shelf.
• Do not use the transceiver near water or sources of moisture. For example, avoid use near a bathtub, sink, swimming pool, or in a
damp basement or attic.
• The presence of an unusual odor or smoke is often a sign of trouble. Immediately turn the power OFF and remove the power cable.
Contact a KENWOOD service station or your dealer for advice.
• Locate the transceiver away from heat sources such as a radiator, stove, amplifier or other devices that produce substantial amounts
of heat.
• Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzene to clean the cabinet of the transceiver. Use only a
clean cloth with warm water or a mild detergent.
•
Disconnect the input power cable from the power source when the transceiver is not used for long periods of time.
• Remove the transceiver's enclosure only to do accessory installations described in this manual or accessory manuals. Follow
provided instructions carefully, to avoid electrical shocks. If unfamiliar with this type of work, seek assistance from an experienced
individual, or have a professional technician do the task.
NOTICES TO THE USER
PRECAUTIONS
EXAMPLE OF ANTENNA GROUNDING
GROUND CLAMP
GROUND CLAMPS
POWER SERVICE GROUNDING ELECTRODE SYSTEM
1
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE UNIT
GROUNDING CONDUCTORS
< HF_NOTICE >