Blocking The Controls - Gabarron MATTIRA MAS18 Instrucciones De Instalacion Y Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

You can temporarily override the automatically calculated set point. If, for example, you want to use the boiler to the
maximum for a few hours even when automatic control mode, you would proceed as follows:
When pressing the
or
button, the display will alternatively show the calculated set point and the indication
. By holding down either of these two keys for at least 5 seconds, the calculated set point will start flashing and
the set point can now be modified with the same keys. Validate the selection by pressing the
button. The time that the
set point is going to be overridden is shown:
. It can be modified from 1 to 24h.
Validate the selection by pressing the
button. The override set point and the time remaining are displayed alternatively
every 10 seconds. At any time, it is possible to cancel this state just by turning off and restarting the boiler

6.8 BLOCKING THE CONTROLS

It is possible to lock the buttons of the control panel to prevent any adjustment.
By keeping the
button pressed down for a few seconds, the control panel will be locked.
The control buttons of the boiler will be locked and no button will respond when pressed. Internally all the settings remain
the same and the boiler will function normally.
To unlock the buttons, press the same button down for a few seconds until the above displayed symbol goes off. If the boiler
is disconnected from the mains or there is a failure in the house's electricity supply, the buttons will also be unlocked.
6.9 PUMP ANTI-SEIZE FUNCTION
The advanced boiler control will automatically energize the pump for 10 seconds each month to protect it from seizing
during long periods of inactivity. The power supply must be maintained for this function to operate.
36

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mattira mas15

Tabla de contenido