Replacing The Remote Batteries; Cleaning Your Speaker System - Bose CINEMATE 1 SR Guia Del Usuario

Ocultar thumbs Ver también para CINEMATE 1 SR:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

C
M
ARE AND
AINTENANCE
Pairing the Acoustimass
Your speaker array and Acoustimass module are paired at the factory. However, should
you ever need to pair them for any reason, do the following:
1. Unplug the Acoustimass module AC power cord.
2. Remove the door on the end of the speaker array.
3. Press and hold the ADAPTiQ
slowly blinking orange.
4. Plug the Acoustimass module AC power cord in the AC outlet.
Pairing is complete when the Acoustimass module status indicator becomes solid
orange and the speaker array status indicator turns off.

Replacing the remote batteries

Replace both batteries when the remote control stops operating or its range seems
reduced. Alkaline batteries are recommended.
1. Slide open the battery compartment cover on the back of the remote.
Battery cover
2. Remove both batteries.
Be sure to dispose of the batteries according to the regulations in your area.
3. Insert two AA (IEC-LR6) 1.5V batteries, or the equivalent. Match the + and – symbols
on the batteries with the + and – markings inside the compartment.
4. Slide the battery compartment cover back into place.

Cleaning your speaker system

• You can clean the surface of the speaker array and Acoustimass
dry cloth.
• Do not use any sprays near the speaker array. Do not use any solvents, chemicals,
or cleaning solutions containing alcohol, ammonia, or abrasives.
• Do not allow liquids to spill into any openings.
• The speaker grille requires no special care, although you may carefully vacuum it with
a brush attachment, if necessary.
14 – English
®
module with the speaker array
®
button for 3-4 seconds until the status indicator starts
AA (IEC LR6)
batteries (2)
®
module with a soft,

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido