Charging Procedure - Porter & Cable PCC761 Manual De Instrucciones

4-1/2 inch (115mm) Type 1 Cutting Wheels
Type 1 guard
Backing flange
abrasive cutting wheel
Clamp nut

ChARGING PROCEdURE

PORTER-CABLE chargers are designed
to charge PORTER-CABLE battery packs.
Charge times are: PCC690L in 35-80 mins.,
PCC691L in 65-140 mins. and PCC695L
in 160-360 mins. depending on the pack
being charged.
1. Plug the charger into an appropriate
outlet before inserting the battery pack.
2. Figure B- Insert the battery pack into the charger.
3. The LED will flash indicating that
the battery is being charged.
4. The completion of charge is indicated
by the LED remaining on continuously.
The pack is fully charged and may be
used at this time or left on the charger.
ChARGER dIAGNOSTICS
This charger is designed to detect certain
problems that can arise with the battery
packs or the power source. Problems are
indicated by one LED flashing in different
patterns.
bAd bATTERY
The charger can detect a weak or
damaged battery. The LED flashes
in the pattern indicated on the label. If you
see this bad battery blink pattern, do not
Type 1 guard
Backing flange
diamond cutting whee
Clamp nut
Wire Wheels
Type 27 guard
3 inch wire cup brush
Sanding discs
continue to charge the battery. Return it
to a service center or a collection site for
recycling.
hOT/COLd PACK dELAY
When the charger detects a battery
that is excessively hot or excessively
cold, it automatically starts a Hot/Cold
Pack Delay, suspending charging until the
battery has normalized. After this happens,
the charger automatically switches to the
Pack Charging mode. This feature ensures
maximum battery life. The light flashes in
the pattern indicated on the label.
PRObLEm POWER LINE
When the charger is used with some
portable power sources such as
generators or sources that convert DC to
AC, the charger may temporarily suspend
operation. The LED flashes in the pattern
indicated on the label. This indicates that
the power source is out of limits.
LEAvING ThE bATTERY IN ThE ChARGER
The charger and battery pack can be
left connected with the LED glowing
indefinitely. The charger will keep the
battery pack fresh and fully charged.
This charger features an automatic tune-
11
Type 27 guard
Protector tipo 27
4 inch wire cup brush
Rubber backing pad
Sanding disc
Threaded clamp nut