Porter & Cable PCC710 Manual De Instrucciones página 10

Multiherramienta oscilante de iones de litio de 20v max*
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
assembly, adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
WARNING:
accessories at any time. Do not touch work piece or blade immediately after operating
the tool. They can become very hot. Handle carefully. Always allow accessories and
work piece to cool before handling.
• Slide the accessory between the shaft and the accessory holder making sure the
accessory engages all pins on the holder and is flush with the shaft (figure 5).
• Release the accessory clamp lever.
• Some accessories, such as scrapers and blades can be mounted at an angle if
required as shown in figure 6.
INSTALLING/REMOVING SANDING ShEETS
A diamond shaped platen uses a hook and loop adhesion system to attach the sanding
sheets. The platen allows you to use it on large flat surfaces and tight spots or corners.
• Attach the sanding platen as described under "Installing/Removing Accessories".
• Align the edges on the sanding sheet, with the edge of the sanding platen and press
the sanding sheet onto the platen as shown in figure 8.
• Firmly press the base with the sanding sheet attached against a flat surface and
briefly switch the tool on. This provides for good adhesion between the platen and the
sanding sheet and also helps to prevent premature wear.
• When the tip of the sanding sheet becomes worn, detach the sheet from the platen,
rotate and reapply.
SWITCh
CAUTION:
(8,000 - 18,000 OPM), the tool will start at the speed where the variable speed dial is
set. Be sure switch is fully OFF before installing battery pack.
CAUTION
:
Do not hold or contact the accessory when inserting or removing the
battery pack or turning the unit on.
• To turn the tool ON, hold it as shown in figure 8 and push the slide switch forward.
• To turn the tool OFF, push the slide switch backward.
NOTE: The tool will start if the switch is left in the "on" position and the battery is inserted. The
switch must be moved to "off" to prevent the tool from immediately starting when battery is inserted.
VARIABLE SPEED DIAL
To operate the tool, select the speed setting you wish with the speed dial, shown in
figure 9, and slide the ON/OFF switch forward. The speed setting can be adjusted
either with the tool on or off.
CAUTION:
(8,000 - 18,000 OPM), the tool will start at the speed where the variable speed dial is
set. Be sure switch is fully OFF before installing battery pack.
The numbered positions,1 through 6 inscribed on the variable speed dial, do not
indicate any precise speed but are good reference points. The higher the number, the
higher the tool speed.
The approximate speed at each setting is:
SPEED SETTING
APPROXIMATE SPEED 8,000 10,000 12,000 14,000 16,000
(Actual OPM's on your tool may vary.)
Be sure to select the proper speed for your oscillating tool operation. If in doubt about
the proper speed for your operation, test the performance at low speed settings and
gradually increase until a comfortable speed is found.
WARNING:
WARNING:
water pipes before making blind or plunge cuts. Failure to do so may result in
Disconnect the plug from the power source before making any
Risk of lacerations or burns. Do not touch the sharp edges of
OPERATION
Because the PCC710 has a separate speed dial for setting the speed
Because the PCC710 has a separate speed dial for setting the speed
1
PLUNGE CUTTING
hold saw firmly with both hands for all cutting operations.
Inspect work area for hidden electrical wiring, gas pipes or
ASSEMBLY
2
3
10
4
5
18,000
6

Publicidad

Tabla de contenido
loading

Tabla de contenido