Hand Brake - BOB IRONMAN Guia Del Usuario

BOB Gear by Britax
Front Wheel Removal
1� Open Brake Quick Release
See Front Wheel Installation
section.
2� Open Quick Release Lever
Move the wheel's quick release
lever from the locked or FULLY
CLOSED position to the FULLY
OPEN position.
3� Remove Through Axle
Loosen the tension adjusting nut
and remove the through axle from
the front wheel and fork.
4� Remove Front Wheel
Raise the front wheel a few inches
off the ground and tap the top of
the wheel with the palm of your
hand to knock the wheel out of
the front fork.

Hand Brake

If you do not understand these
instructions, or feel the brake
is adjusted incorrectly, take
the stroller to your dealer for
proper adjustment� If your
brake pads are worn, see your
dealer for replacements�
The hand brake may be used to help
slow or stop a stroller. The hand
brake is not a parking brake.
NOTE: For the hand brake to work
correctly, it is critical that it be
adjusted properly. Squeeze the brake
8
lever and verify that the brake pads
contact the rim. Verify brake quick
release is in closed position. See
Front Wheel Installation section.
The hand brake system is equipped
with two barrel adjusters. If you
are not familiar with how to use the
barrel adjusters, please contact BOB
Gear by Britax customer service or
visit your local dealer for assistance.
1� Align Brake Pads
If brakes are misaligned, use a
10mm wrench to loosen brake
pad nuts, slide pads into correct
position and tighten securely.
Brake Caliper
Brake Pad Aligned With Rim
2� Adjust Cable Tension
The cable tension is pre-adjusted
at the factory, but the brake cable
will need periodic adjustment
(as the cable stretches slightly
and the black cable housing
compresses over time).
To adjust cable tension, there
are two barrel adjusters in the
brake system; one at the hand
brake lever, and one at the
caliper brake. To adjust the
brake cable tension, one or both
barrel adjusters may need to be
adjusted.
Hand Brake
Hand Brake
Lever
Handlebar
Lock Ring
Barrel Adjuster