Age Guidelines
Prior to first use, consult with your
pediatrician regarding suitability of
stroller use with your child.
Please note that infants incapable
of holding their head up must have
additional head and neck support to
ride safely and comfortably. From 0-8
weeks, or as recommended by your
pediatrician, the use of an infant car
seat and adapter is encouraged.
Children are unique and develop at
different rates. Most may not have the
neck strength for jogging or off-road
motion until 8 months of age. For
jogging or off-road stroller use, BOB
Gear by Britax recommends you limit
use of this stroller to children over the
age of 8 months.
Please refer to the below table for
age/use guidelines:
RECOMMENDED STROLLER USE
0 - 8 Weeks
8 Weeks - 8 Months
8 Months - 5 Years
* See BOB Infant Car Seat Adapter User
Guide for maximum occupant weight.
IRONMAN/SPORT UTILITY STROLLER User Guide
Walk Only with
Infant Car Seat &
Adapter *
Walk Only
Jogging/Off-Road
Stroller Assembly
Unpacking the Stroller
Remove all packaging materials
and discard to avoid choking
and suffocation hazards�
Fender Installation
Before installing the front wheel, you
will need to attach the fender.
1� Remove Mounting Screws
Two fender mounting screws can
be found already installed in the
stroller frame. Remove the two
fender mounting screws with a
Phillips head screwdriver.
Mounting Holes
NOTE: You might want to remove
a fabric screw (right or left) to give
better access to the cross tube
mounting hole.
2� Align Fender and Cross Tube Hole
Align the hole in the tab of the
fender with the threaded hole in
the center of the front cross tube
and install screw.
3� Align Fender and Brake
Mounting Hole
Align the hole in the fender with
the hole in the brake mounting
plate and install screw.
4� Tighten Screws
Center fender on stroller and
tighten screws. Reinstall and
tighten any additional fabric
screws that had been removed.
Front
Fender
5