Converting From Vacuum To Blower; Connecting To A Power Source - Toro 51593 Manual Del Operador

Ocultar thumbs Ver también para 51593:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
3.
Install the vacuum bag.
4.
Adjust the strap as needed for comfortable operation.
3

Converting from Vacuum to Blower

Parts needed for this procedure:
1.
Remove the vacuum bag and the vacuum tube from the blower
housing.
2.
Install the blower tube and then the inlet cover onto the blower
housing.
NOTICE! The blower will not run unless the bottom inlet cover
is locked in place.
Operation
NOTICE! This blower is intended for outdoor, residential use only.
Do not use it indoors or for commercial or industrial purposes.

Connecting to a Power Source

The power supply you use with this appliance should be a residential
current device (RCD) with a tripping current of not more than 30 mA.
Use only a CE approved extension cord recommended for outdoor
use. Do not change the appliance or extension cord plug in any way.
WARNING
If you do not fully seat the extension cord on the inlet plug, or if
the plug and cord do not fit firmly, the loose plug could lead to
overheating and cause a fire, possibly burning you or others.
Ensure that you fully seat the cord on the plug.
Check the connection regularly to ensure that the cord is
firmly attached.
Do not use a worn-out or loose extension cord.
Extension Cord Length
30 m
45 m
Note: Do not use an extension cord over 45 m.
NOTICE! Check the extension cord frequently during use for
holes in the insulation. Do not use a damaged cord. Do not run
the cord through standing water or wet grass.
Secure the extension cord to the blower cord using an overhand knot,
as shown.
4
Minimum Wire Gage
1.0 mm
2
2.0 mm
2

Publicidad

Tabla de contenido
loading

Tabla de contenido