Glass 1989 POP Serie Manual De Uso página 25

can be adjusted using button (6).
keep pressing the button (4) at least for
3 seconds, the airpool system starts in
variable mode (by the maximum intensity
to the minimum).
WARNING: the Blowing After works
only when the bathtub is empty. Do
not use the bathtub during the cycle.
Drain the bathtub completely at the end
of the cycle.
To start the "blowing after", push the button
(4). The "airpool system functioning" led
starts flashing. to confirm the start-up of
the function, push again the button at the
third flash.
SANITIZING FUNCTION
(only if available on the model)
Fill the bathtub up in order to start the
sanitizing function system.
To start the SANITIZATION function, push
the button (2) at least for 3 seconds. The
"SANITIZATION system functioning" led
starts flashing in YELLOW colour. To
confirm the start-up of the function, push
again the button at the third flash and the
led turns into RED.
If the disinfectant or the water level are
missing, the sanitization function does not
work. This status is indicated by "flashing
red led".
•Lift the cap of the dispenser on the
edge of the bathtub and fill it with the
disinfectant.
• the water level is missing, fill further
the bathtub, over the level of the jets.
No other function is available during this
cycle.
At the end of the cycle, the led keeps
being alight until the bathtub is completely
emptied. then, we suggest doing a
"blowing after" cycle of the airpool circuit,
by pushing the airpool button (4).
WARNING: do not use the bathtub
during the cycle. drain the bathtub
completely at the end of the sanitization
cycle.
7
EN