Glass 1989 POP Serie Manual De Uso página 27

missing; fill further the bathtub, over the
level of the jets. if there is no water, the
airpool does not work.
the airpool system starts the cycle at the
maximum intensity. the airpool intensity
can be adjusted using button (4).
EN
Keep the button (4) pressed down for
more than 3 sec. to activate the AIRPOOL
system in the adjustment mode; the
GREEN led starts blinking. Press the
button (4) while the led is blinking in order
to adjust the speed.
WARNING: the Blowing After works
only when the bathtub is empty. Do
not use the bathtub during the cycle.
Drain the bathtub completely at the end
of the cycle.
To start the "blowing after", push the button
(4). The "airpool system functioning" led
starts flashing. to confirm the start-up of
the function, push again the button at the
third flash.
LIGHT
In order to set up the function LIGHT press
the on/off button (6) has a pre-set time of
approximately 15 minutes.
just press the same button again to turn
off the light.
9