Installation - Alpha IP RTD 61001 Serie Manual De Instrucciones

HAP 21001).
1. Open the Alpha IP app on the smart phone.
2. Select the menu item Teach-in device.
3. Release the room control unit Display from the installation bottom (see fig. 3
page 5).
4. Pull out the insulating strip from the battery compartment, or insert batteries
(see fig. 4 page 5). If Batteries are inserted, shortly press the system key (D)
in order to activate the teach-in mode.
5. The device is displayed automatically in the Alpha IP app.
6. Enter the last four ciphers of the device number (SGTIN) or scan the supplied QR
code for confirmation. The device number can be found below the QR code or
in the battery compartment.
The LED will light up in green after a successful teach-in process. If the
LED lights up red, repeat the process.
7. Follow the instructions in the app.

5.2 Installation

The place of installation can be selected flexibly due to the battery operation. In-
stallation can be performed with screws, with the supplied adhesive strips, or in
a flush-type box.
Commissioning
41