Machine Description - JMA MULTICODE SINGLE Manual De Instrucciones

2.2 INSTALLATION
The machine is assembled, calibrated and controlled ready for use and does not need any assembly operations. In all
cases, before the first start-up, the following controls should be made:
• Connect the MULTICODE SINGLE machine to adequate voltage power supply (220V 50Hz or 110V 50/60 Hz)
using the supplied power unit (See section 2.1.3)
• It is very important that the electrical installation of the establishment has an earth connection. Make sure that
the machine is connected to earth.
After having unpacked the machine and connected the supplied cable to the power outlet, the machine is ready for
use.
Make sure the emergency button is not pressed, if it is, unblock it.
After starting the machine, the carriages will move to the start position (if they are not there already) and a green light
will show on the display. (Fig. 10)
The MULTICODE SINGLE machine, will only work if it is connected to the TABLET with the JMAKeyPro program. The
communication between the software and the machine is via Bluetooth.
This said, switch the tablet on and then activate the software. After having activated the program, a blue light will
show on the display. (Fig. 10) The machine is now prepared to operate.

2.3 MACHINE DESCRIPTION

The MULTICODE SINGLE machine has been designed to cut flat keys. During the design phase, the minimal details
have been analysed to manufacture a compact machine, easy to use and that is very precise. This is a Mecatronics
machine, with stepper motors for displacement of the carriages.
54
OPERATION
FIG. 10