Heater Components; Getting Started And Use - Blumfeldt Dark Wave Stand Manual Del Usuario

HEATER COMPONENTS

1 Aluminum box
2 Plastic cover
3 Aluminum fuselage
4 Heating tube

GETTING STARTED AND USE

1. Plug in and use the power switch in the rear right side to connect the
power.
2. Press in the right side panel to switch on the heater and choose 9
different settings.
3. Press in the right side panel to set 24 hours power off.
How to operate the unit using the remote control
The functions of the heater may be controlled via the buttons on your remote
control and LED screen. You may also control some of the functions of your
heater through the buttons on the front side of the heater.
1. Plug in and use the power switch in the rear right side to connect the
power.
2. Press in the remote to make the heater standby.
3. Press , to increase the heating level until F9.
4. Press , to decrease the heating level until F1.
5. Press P1 the heater is in half of full power.
6. Press P2 the heater is in full power.
7. Press to set 24 hours power off.
5 Heating tube
6 Right housing
7 LED displayer
8 Protection grill
EN
23