D-Link DP-301U Guía De Instalación Rápida página 3

Connecting The DP-301U
To Your Network
First, insert one end of a straight-through CAT5 Ethernet RJ-45 cable into
the "Network Port" (shown below.) Connect the other end of the cable to the
LAN port of the gateway or switch.
Note: Do not connect the power cord to the DP-301U until you are advised
to do so
Warning! Only a USB printer may be connected to the USB port of the DP-301U.
Do not connect any other USB device to the USB port; to do so may damage the unit,
voiding the warranty for this product.
Next, make sure that the Printer is turned OFF.
Using the USB cable, connect one end of the cable to the USB port of the
DP-301U (shown below) and the other end to the USB port of the printer.
Turn ON the printer.
Receptor for AC
Power Adapter
Then, plug one end of the power adapter into the DP-301U and the other
end into your electric outlet.
The DP-301U will turn on and begin a self-test.
For Mac OS printing, please refer to users manual located on CD-ROM
3
USB Port
Network Port