Chapter Iintroduction - Mr. Heater MH25NG Instrucciones De Funcionamiento Y Manual Del Propietario

CHAPTER I
INTRODUCTION
1. EQUIPMENT
This heater is the consumer version of our highly suc-
cessful, thoroughly tested, gas fired, infrared, industrial
utility heater.
This heater does not require an external electrical
source for operation.
The major components of the heater and a typical
installation are identified in Figure 1. The basic heater
GAS CONTROL
VALVE
POWERPILE
GENERATOR
THERMOSTAT
CABLE
THERMOSTAT
Figure 1. Heater Major Components
consists of the complete burner assembly, flue deflec-
tor, grid, reflector assembly and face guard.
2. PURPOSE OF EQUIPMENT
WARNINGS
This heater is for indoor installation only.
This heater is designed to heat indoor areas. Do not
use for inhabited or small, enclosed areas.
BASIC HEATER
WALL MOUNTING
BRACKET
Installation instructions and Owner's Manual
E3
EXHAUST
VENT